ELTEX ESR-3100 - Page 444

ESR series service routers.ESR-Series. User manual
444
Step Description Command Keys
4 Add RADIUS server to the list of
used servers and switch to its
configuration mode.
esr(config)# radius-server host
{ <IP-ADDR> | <IPV6-ADDR> } [ vrf
<VRF> ]
esr(config-radius-server)#
<IP-ADDR> – RADIUS server IP
address, defined as
AAA.BBB.CCC.DDD where each part
takes values of [0..255];
<IPV6-ADDR> – RADIUS server IPv6
address, defined as X:X:X:X::X where
each part takes values in
hexadecimal format [0..FFFF]
<VRF> – VRF instance name, set by
the string of up to 31 characters.
5 Specify the number of failed
authentication attempts to block
the user login and time of the
lock (optional).
aaa authentication attempts max-
fail <COUNT> <TIME>
<COUNT> – amount of failed
authentication attempts after which
a user is blocked, takes the values of
[1..65535];
<TIME> – user blocking time in
seconds, takes the values of
[1..65535].
Default value:
<COUNT> – 5; <TIME> – 300
6 Set the password for
authentication on remote RADIUS
server.
esr(config-radius-server)# key
ascii-text
{ <TEXT> | encrypted
<ENCRYPTED-TEXT> }
<TEXT> – string [8..16] ASCII
characters;
<ENCRYPTED-TEXT> – encrypted
password, [8..16] bytes size, set by
the string of [16..32] characters.
7 Set the priority for using a remote
RADIUS server (optional).
esr(config-radius-server)#
priority <PRIORITY>
<PRIORITY> – remote server priority,
takes values in the range of
[1..65535].
The lower value, the higher the
priority of server is.
Default value: 1.
8 Set the interval after which the
router assumes that the RADIUS
server is not available (optional).
esr(config-radius-server)#
timeout <SEC>
<SEC> – time interval in seconds,
takes values of [1..30].
Default value: global timer value is
used.