ELTEX ESR-3100 - Page 258

ESR series service routers.ESR-Series. User manual
258
Step Description Command Keys
38 Set the time interval in seconds after
which the router re-sends a packet that
has not received a delivery confirmation
(for example, a DatabaseDescription
packet or LinkStateRequest packets.
Optional).
esr(config-if-gi)# ip ospf
restransmit-interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 5 seconds.
esr(config-if-gi)# ipv6 ospf
restransmit-interval <TIME>
39 Set the time interval in seconds after
which the router sends the next hello
packet(optional).
esr(config-if-gi)# ip ospf hello-
interval <TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 10 seconds.
esr(config-if-gi)# ipv6 ospf hello-
interval <TIME>
40 Set the time interval in seconds after
which the neighbor is considered to be
idle (optional). This interval should be a
multiple of the ‘hello interval’ value.
esr(config-if-gi)# ip dead-interval
<TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 40 seconds.
esr(config-if-gi)# ipv6 dead-
interval <TIME>
41 Set the time interval during which
NBMA interface waits before sending a
HELLO packet to a neighbor, even if the
neighbor is inactive (optional).
esr(config-if-gi)# ip poll-interval
<TIME>
<TIME> – time in seconds,
takes values of [1..65535].
Default value: 120 seconds.
esr(config-if-gi)# ipv6 poll-interval
<TIME>
42 Set static IP address of a neighbor to
establish a relation in NMBA and P2MP
(Point-to-MultiPoint)
networks(optional).
esr(config-if-gi)# ip ospf neighbor
<IP> [ eligible ]
<IP> – neighbor’s IP address,
defined as AAA.BBB.CCC.DDD
where each part takes values
of [0..255].
eligible – optional parameter,
allows the device to take part in
DR selection process in NMBA
networks. The interface priority
should be greater than zero.
esr(config-if-gi)# ip ospf neighbor
<IP> [ eligible ]
<IPV6-ADDR> – neighbor’s IPv6
address, defined as X:X:X:X::X
where each part takes values in
hexadecimal format [0..FFFF];
eligible – optional parameter,
allows the device to take part in
DR selection process in NMBA
networks. The interface priority
should be greater than zero.