ELTEX ESR-3100 User Manual

ESR series service routers.ESR-Series. User manual
300
Step Description Command Keys
esr(config-wan-target)# ipv6
address <IPV6-ADDR>
<IPV6-ADDR> – destination IPv6
address, defined as X:X:X:X::X
where each part takes values in
hexadecimal format [0..FFFF].
13 Enable target check. esr(config-wan-target)# enable
Commands for 14–17 items should be applied on interfaces/tunnels in MultiWAN.
14 Enable WAN mode on the interface for
IPv4/IPv6 stack.
esr(config-if-gi)# wan load-
balance enable
esr(config-if-gi)# ipv6 wan load-
balance enable
15 Set the amount of ineffective attempts
to check the connection, after which, if
there is not response from the opposing
side, the connection is considered to be
inactive (optional).
esr(config-if-gi)# wan load-
balance failure-count <VALUE>
<VALUE> – number of attempts,
takes values in the range of
[1..10].
Default value: 1.
esr(config-if-gi)# ipv6 wan load-
balance failure-count <VALUE>
16 Set the amount of successful attempts
to check the connection, after which, if
successful, the connection is
considered to be active again (optional).
esr(config-if-gi)# wan load-
balance success-count <VALUE>
<VALUE> – number of attempts,
takes values in the range of
[1..10].
Default value: 1.
esr(config-if-gi)# ipv6 wan load-
balance success-count <VALUE>
17 Set a neighbor's IP address that will be
indicated as one of the gateways in a
static route created by MultiWAN
service.
esr(config-if-gi)# wan load-
balance nexthop { <IP> | dhcp
enable | tunnel enable }
<IP> – destination IP address
(gateway), defined as
AAA.BBB.CCC.DDD where each
part takes values of [0..255].
dhcp enable – if on the
interface an IP address is
obtained through a DHCP client,
the gateway from the DHCP
server is used.
tunnel enable – use as nexthop
– destination p-t-p address.
Applicable for the interfaced
being connected that operate
via ppp.

ELTEX ESR-3100 Specifications

General

Brand	ELTEX
Model	ESR-3100
Category	Network Router
Language	English