EasyManuals Logo

ELTEX ESR-3100 User Manual

Default Icon
650 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #318 background imageLoading...
Page #318 background image
ESR series service routers.ESR-Series. User manual
318
ESR routers have the ability to flexibly configure Hello holdtime, Hello interval and Keepalive holdtime settings.
Example of configuring Hello holdtime for an LDP session:
ESR# show run mpls
mpls
 ldp
 router-id 4.4.4.4
  discovery hello holdtime 40
 address-family ipv4
 interface gigabitethernet 1/0/4
      discovery hello holdtime 60
 exit
 exit
 enable
exit
If the Hello Holdtime and Hello Interval parameters are not specified, the default values are used. If parameters
are specified, the priority of values for address-family will be higher than for globally configured values.
ESR# show mpls ldp discovery detailed
Local LDP ID: 4.4.4.4
Discovery sources:
 Interfaces:
 gigabitethernet 1/0/4:
   Hello interval: 5 seconds
    Transport IP address: 4.4.4.4
    LDP ID: 1.1.1.1
    Source IP address: 10.10.10.1
    Transport IP address: 1.1.1.1
    Hold time: 15 seconds
                 Proposed hold time: 60 /15 (local/peer) seconds
The parameters configured in address-family can be configured for each individual interface participating in
the LDP process.
ESR# show running-config mpls
mpls
 ldp
 router-id 4.4.4.4
 discovery hello holdtime 50
 discovery hello interval 10
 address-family ipv4
      interface gigabitethernet 1/0/1
        discovery hello holdtime 60
        discovery hello interval 20
 exit
      interface gigabitethernet 1/0/4
        discovery hello holdtime 30
        discovery hello interval 10
 exit
 exit
 enable
exit
For a TCP session, Keepalive holdtime is also a matching parameter similar to Hold timer. Keepalive interval is
calculated automatically and equals Keepalive holdtime/3. Keepalive holdtime can be set globally as well as
for each neighbor. The timer set for a particular neighbor is a higher priority.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the ELTEX ESR-3100 and is the answer not in the manual?

ELTEX ESR-3100 Specifications

General IconGeneral
BrandELTEX
ModelESR-3100
CategoryNetwork Router
LanguageEnglish

Related product manuals