ELTEX ESR-3100 - Page 500

ESR series service routers.ESR-Series. User manual
500
•
•
Step Description Command Keys
18 Set the number of
downloadable rules.
esr (config-ips-vendor-category)# rules
count <number>
<number>
19 Enable category. enable
20 Switch to the IPS/IDS
configuration mode.
esr (config)# security ips
21 Assign IPS/IDS security
policy.
esr(config-ips)# policy <NAME> <NAME> – security policy name, set
by the string of up to 32 characters.
22 Use all ESR resources
for IPS/IDS (optional).
esr(config-ips)# perfomance max
23 Set remote server
parameters for sending
IPS/IDS service
statistics in EVE format
(elasticsearch)
(optional).
esr(config-ips)# logging remote-server
{ <ADDR> | <IPV6-ADDR> }
[ <TRANSPORT> ] [ <PORT> ] [ source-
address { <SRC-ADDR> | <IPV6-SRC-
ADDR> } ]
<ADDR> – sender IP address, defined
as AAA.BBB.CCC.DDD where each
part takes values of [0..255];
<IPV6-ADDR> – IPv6 address, defined
as X:X:X:X::X where each part takes
values in hexadecimal format
[0..FFFF];
<TRANSPORT> – data transfer
protocol, by default is UDP, takes the
following values:
TCP – data transfer via TCP;
UDP – data transfer via UDP.
<PORT> – number of sender TCP/
UDP port, takes values of [1..65535],
by default is 514;
<SRC-ADDR> –IPv4 address of the
router that will be used as the source
IP address in the sent syslog packets.
By default – the IPv4 address of the
interface from which the packets are
sent;
<IPV6-SRC-ADDR> – IPv6 address of
the router that will be used as the
source IP address in the sent syslog
packets. By default – the IPv6
address of the interface from which
the packets are sent.
24 Set the interval for
sending IPS/IDS service
statistics in EVE
(elasticsearch) format
(optional).
esr(config-ips)# logging update-interval
<INTERVAL>