EOS P 396 - Topquality; Overview of PPP Properties

5
Part Property Management
5.8
Training manual • Basic training • Status 03.14
EOS P 396
TopQuality
The PPP parameter set TopQuality is built with a layer thickness of 0.06 mm. With
this layer thickness it is possible to build small to medium-sized parts with extremely
fine and fragile geometries and the highest surface quality. The building height with
this parameter set is limited to 300 mm.
Example part PPP TopQuality
Overview of PPP properties
The appropriate PPP parameter set can be selected depending on the required part
properties and manufacturing requirements:
TopSpeed Speed Balance
Performance
TopQuality
Productivity
Mechanical
properties
Surface
Accuracy
to shape
Process stability
= acceptable
= best possible
...