Part Property Management
5.11
Training manual • Basic training • Status 03.14
EOS P 396
5
➢ Exposure type No_Exposure
If a part is allocated this exposure type, it is not exposed during the building
process.
Exposure editor
Using the Exposure editor module, new, custom exposure types with custom
parameters can be prepared. The basic exposure types in the Exposure editor do not
contain any initial values that can be used for building. These values must be
prepared independently or obtained using the Initial values for parameters module.
Possible applications:
➢ Process optimisation for special applications
➢ Development of optimised exposure parameters for parts with very complex
geometries
➢ Research and development in the area of laser sintering.
Exposure parameters window
You will find an overview of the exposure types in the Exposure editor module in
the Operation manual, section 5, Exposure types in the Exposure editor module.
To Next Page
Loading...