5
Part Property Management
5.12
Training manual • Basic training • Status 03.14
EOS P 396
Initial values for parameters
The Initial values for parameters module provides, in addition to the functionality of
the Exposure editor module, an additional exposure type with parameters that can be
edited. These parameters are pre-defined such that it is possible to build parts on
which there are no special requirements. By deriving a new, custom exposure type
and changing the parameters, special requirements for applications and parts can be
met.
You will find an overview of the exposure types in the Initial values for
parameters module in the Operation manual, section 5, Exposure types in the
Initial values for parameters module.
To Next Page
Loading...