CHAPTER 6
Video terminal VT150W
405.1200.037.2 - Rel.: 2.21 of 25/02/2008
6-16
• Switch on the VT with pressed down or with the VT on press
together + ; in either case wait a moment
VT terminal with no Modem function:
• The following mask appears. The VT is now ready to receive (refer to
Software Manual for transfer procedure)
VT terminal with Modem function:
• The following mask appears
• Choose the required transfer mode: MODEM if you intend to use a
modem or PC if you intend to use a serial port; press the corresponding
function
If the choose made is PC, the VT is ready to receive (see Software Manual
for transfer), if, on the other hand, you choose MODEM, the following
mask will appear
The choice should be according to the speed you intend to use for the trans-
fer (Slow=9600bit/sec or Fast=38400bit/sec), press the corresponding func-
tion . The VT is now ready to receive (see Software Manual for the
transfer).
Enter
shift
Enter
Boot forced
F1=MODEM - F2= PC
F1=FAST - F2=SLOW
To Next Page
Loading...
