CHAPTER 4
Video terminal VT60
405.1200.037.2 - Rel.: 2.21 of 25/02/2008
4-14
The choice should be according to the speed you intend to use for the trans-
fer (Slow=9600bit/sec or Fast=38400bit/sec), press the corresponding func-
tion . The VT is now ready to receive (see Software Manual for the
transfer).
Information
relating to
driver
After the project has been transferred, the VT can make available informa-
tion relating to what has been loaded. The information regards:
• The name of the driver loaded
• The version of the driver loaded
• Network address of the VT
• Last error to have occurred
To acquire this information carry out the following operations:
• Be situated in any page of the project
• Press twice; you now see
The possible error messages are:
• PROT ERROR
Problem-> Errors have been detected in the data exchange between
the VT and the Device.
Solution-> Check the cable; there may be disturbance.
• COM BROK
Problem-> Communication between VT and Device interrupted.
Solution-> Check the serial connection cable.
F1=FAST - F2=SLOW
Shift
Driver: xxxxxxxxxxxxx
Ver. : xxxxxxxxxxxxx
Addr. : xxxxxxxxxxxxx
Error : xxxxxxxxxxxxx
To Next Page
Loading...
