405.1200.037.2 - Rel.: 2.21 of 25/02/2008
5-15
• Choose the required transfer mode: MODEM if you intend to use a
modem, PC if you intend to use a serial port or BACK if you intend
return to previous mask; press the corresponding function
If the choose made is PC, the VT is ready to receive (see Software Manual
for transfer), if, on the other hand, you choose MODEM, the following
mask will appear
The choice should be according to the speed you intend to use for the trans-
fer (Slow=9600bit/sec or Fast=38400bit/sec), press the corresponding func-
tion . The VT is now ready to receive (see Software Manual for the
transfer).
Information
relating to
driver
After the project has been transferred, the VT can make available informa-
tion relating to what has been loaded. The information regards:
• Serial ports present
• The name of the driver loaded
• The version of the driver loaded
• Network address of the VT
• Last error to have occurred
To acquire this information carry out the following operations:
• Be situated in any page of the project
• Press twice; you will see
VT130W TRANSFER PAGE
BOOT/RAM check: OK
FIRMWARE check: OK
--- DOWNLOADER MENU ---
F1:MODEM F2:PC
F3:BACK
VT130W TRANSFER PAGE
BOOT/RAM check: OK
FIRMWARE check: OK
--- DOWNLOADER MENU ---
F1:SLOW F2:FAST
F3:BACK
Shift
To Next Page
