CHAPTER 13
Video terminal VT330W
405.1200.037.2 - Rel.: 2.21 of 25/02/2008
13-14
Preparation for
reception
The program VTWIN (see Software Manual) must be used for the transfer,
but the terminal must be set up to receive. This means carrying out the fol-
lowing steps:
• Check that the VT is off
• Check that there is a serial connection between the PC and the VT
• Switch on the VT; when the message [WAIT FOR BOOT FORCED] is
displayed, press , or with the VT on press together + ; in
either case wait a moment
VT terminal with no Modem function:
• The following mask appears. F3=MemoCARD is only enabled when a
Memory Card has been inserted in the VT terminal (see Page 13-18).
The function to press depends on which port you intend to use (MSP
or ASP). The VT is now ready to receive (refer to Software Manual for
transfer procedure)
VT terminal with Modem function:
Proceed from the preceding mask; the following mask appears
Enter
Shift Enter
VT330W TRANSFER PAGE
Graphic controller BOOT check : OK
Graphic controller RAM check : OK
Main BOOT and RAM check : OK
Graphic controller synchronization : OK
Main FIRMWARE check : NOT PRESENT
Graphic controller FIRMWARE : ERROR
F1=MSP F2=ASP F3=MemoCARD ENTER=Prj
To Next Page
Loading...
