405.1200.037.2 - Rel.: 2.21 of 25/02/2008
13-15
• Choose the required transfer mode: MODEM if you intend to use a
modem or PC if you intend to use a serial port; press the corresponding
function
If the choose made is PC, the VT is ready to receive (see Software Manual
for transfer), if, on the other hand, you choose MODEM, the following
mask will appear
VT330W TRANSFER PAGE
Graphic controller BOOT check : OK
Graphic controller RAM check : OK
Main BOOT and RAM check : OK
Graphic controller synchronization : OK
Main FIRMWARE check : NOT PRESENT
Graphic controller FIRMWARE : ERROR
F1=MODEM F2=PC ENTER=Prj
VT330W TRANSFER PAGE
Graphic controller BOOT check : OK
Graphic controller RAM check : OK
Main BOOT and RAM check : OK
Graphic controller synchronization : OK
Main FIRMWARE check : NOT PRESENT
Graphic controller FIRMWARE : ERROR
F1=SLOW F2=FAST
To Next Page
Loading...
