405.1200.037.2 - Rel.: 2.21 of 25/02/2008
5-17
Use and/or to select the field and and/or to effect any
variation; use to confirm.
Possible error messages are:
• PR ERR
Problem-> Errors have been detected in the data exchange between
the VT and the Device.
Solution-> Check the cable; there may be disturbance.
• COM BROKEN
Problem-> Communication between VT and Device interrupted.
Solution-> Check the serial connection cable.
An error message followed by [*] indicates that the error is not currently
present but was and has since disappeared.
Example: COM BROKEN*
When is pressed you quit the display of information regarding the
driver.
Adjusting the
contrast on
the display
To improve the quality of the representation on the display it may be neces-
sary to adjust its contrast. This can be done by going to the page proposed
(see Page 5-16) and changing the value (from +31 to -31) in evidence at
that moment. Increase the value to darken the display; to lighten it decrease
the value.
We advise this to be done at typical room temperature and with the terminal
at operating temperature (about 30 minutes after switching on and with the
screen saver disabled - see Software Manual).
hh:mm:ss dd/mm/yy
.
±
Space
Pg
Up
Pg
Dn
Enter
Esc
Clr
To Next Page
Loading...
