405.1200.037.2 - Rel.: 2.21 of 25/02/2008
18-25
see the following mask
The VT terminal is now ready to receive (consult Software Manual
for information on the transmission procedure).
Possible error messages that may be encountered in the driver information
page are:
• PR ERR
Problem-> Errors have been detected in the data exchange between
the VT and the Device.
Solution-> Check the cable; there may be disturbance.
• COM BROKEN
Problem-> Communication between VT and Device interrupted.
Solution-> Check the serial connection cable.
An error message followed by [*] indicates that the error is not currently
present but was and has since disappeared.
Example: COM BROKEN*
When is pressed you quit the display of information regarding the driver.
Adjusting the
contrast on
the display
To improve the quality of the representation on the display it may be neces-
sary to adjust its contrast. This can be done by going to the page proposed
(see Page 18-23) and changing the value (from +31 to -32) in evidence at
that moment. Increase the value to darken the display; to lighten it, decrease
the value.
VT515 TRANSFER PAGE
*** WAITING FOR DOWNLOAD FROM MSP ***
ESC
To Next Page
Loading...
