405.1200.037.2 - Rel.: 2.21 of 25/02/2008
4-13
• Free terminal protocol
For this it is essential that the VT be prepared to receive the transfer. (See
also
“Chapter 38 -> Command area“).
Preparation for
reception
The program VTWIN (see Software Manual) must be used for the transfer,
but the terminal must be set up to receive. This means carrying out the fol-
lowing steps:
• Check that the VT is off
• Check that there is a serial connection between the PC and the VT
• Switch on the VT with pressed down and wait a moment
VT terminal with no Modem function:
• The following mask appears. The VT is now ready to receive (refer to
Software Manual for transfer procedure)
VT terminal with Modem function:
• The following mask appears
• Choose the required transfer mode: MODEM if you intend to use a
modem or PC if you intend to use a serial port; press the corresponding
function
If the choose made is PC, the VT is ready to receive (see Software Manual
for transfer), if, on the other hand, you choose MODEM, the following
mask will appear
F4
Enter
VT60 Service page
F1=MODEM - F2= PC
To Next Page
Loading...
