405.1200.037.2 - Rel.: 2.21 of 25/02/2008
5-13
To fix the sealing gasket and secure the VT to the container see “Chapter 30
-> Mounting the terminal within the container“
.
Where accessories need to be fixed in or onto the VT terminal, you
are advised to do this before securing the VT to its container.
Accessories Any accessories should be mounted in accordance with the instructions in
the relevant chapter (see
“Chapter 34 -> Video terminal accessories“).
Transfer PC ->
VT
For everything to function properly, the first time the VT operator terminal
is switched on it needs to be correctly loaded, that is it needs to have trans-
ferred to it:
• Firmware
• Communication driver
• Project
(Given that the transfer of the three files in practice occurs with a single
operation, it will be defined as “Project transfer” for the sake of simplicity.)
For this it is essential that the VT be prepared to receive the transfer. (See
also
“Chapter 38 -> Command area“).
To Next Page
Loading...
