405.1200.037.2 - Rel.: 2.21 of 25/02/2008
23-13
VT terminal with Modem function:
• Proceed from the preceding mask; the following mask appears
• Choose the required transfer mode: MODEM if you intend to use a
modem or PC if you intend to use a serial port; touch the relevant on
the display
If the choose made is PC, the VT is ready to receive (see Software Manual
for transfer), if, on the other hand, you choose MODEM, the following
mask will appear
VT565 TRANSFER PAGE
Graphic controller BOOT check : OK
Graphic controller RAM check : OK
Main BOOT and RAM check : WAIT
SELECT:
MSP ASP EXITMemoCARD
VT565 TRANSFER PAGE
Graphic controller BOOT check : OK
Graphic controller RAM check : OK
Main BOOT and RAM check : WAIT
SELECT:
MODEM PC EXIT
To Next Page
Loading...
