Evolis Avansia - Page 92

Service Manual_AVA1_ENG-20220922_I 92
Printer Setup >
Parallel Print
Overview
ON/OFF of the parallel process function for multiple cards
Detail
To set ON/OFF of the parallel process function for multiple cards.
ON: Perform the parallel processing (continuous printing). Print up
to 2 cards at once
through parallel processing in the printer.
OFF:
Do not perform the parallel processing (prints one card at a
time).
Do not print another
card until the previous card finishes printing (normal eject).
Adj/Set/Operate
Method
Select the setting value.
Press the SET key, and then confirm the setting value.
Caution
Set this item according to the specification of the card printing
system.
Adj/Set/Operate
Method
ON OFF
Default Value
ON
Short Size Print
Overview
ON/OFF of the partial printing of color data
Detail
To set ON/OFF of the card empty detection when waiting
OFF
: Always print (temporary transfer) on the entire surface of card
ON: Perform the partial printing (primary transfer) on the effective
area (region with
data other than 0 tone) only within color data.
The
design or layout of the color data
may reduce the time required to
print the cards.
Adj/Set/Operate
Method
Select the setting value.
Press the SET key, and then confirm the setting value.
Short Size Print
Display/Adj/Set
Range
ON OFF
Default Value
OFF
Initialize Mode
Overview
Set of the initializing actions
Detail
RENEW: Initializes when turning on the power and clearing errors.
Updates the ink
ribbon and transfer film (*1).
BEFORE
PRINTING: Initializes when printing the first time after
turning
on the power. Does not initialize when turning on the power
or
clearing errors.
NORMAL: Initializes when turning on the power and clearing errors.
Does not update
the ink ribbon and transfer film.
*1:
Discards a specified amount of ink ribbon and transfer film every
third initialization operation and uses a new area.
Adj/Set/Operate
Method
Select the setting value.
Press the SET key, and then confirm the setting value.
Display/Adj/Set
Range
RENEW BEFORE PRINTING NORMAL
Default Value
RENEW
Language
Overview
Language setting for displaying error messages and user mode
menu on the LCD screen
Detail
Sets the language to be used for displaying error messages and for
the user mode menu on the LCD screen.
Adj/Set/Operate
Method
Select the setting value.
Press the SET key, and then confirm the setting value.
Display/Adj/Set
Range
ENGLISH CHINESE
Default Value
ENGLISH
Revision Check
Overview
Moves to the setting menu of the printer configuration (revision)
Adj/Set/Operate
Method
Select the item, and then press SET key.
Display/Adj/Set
Range
Revision
Rbn Back Tension
Ribbn Tension Platen Nip Duty Thermister
Heat Roller
FilmTension(1st)
Gensokuhi
Dm2
Heating Time
Overview
Display of heat roller high temperature heating time