Service Manual_AVA1_ENG-20220922_I 93
ON/OFF of the parallel process function for multiple cards
To set ON/OFF of the parallel process function for multiple cards.
ON: Perform the parallel processing (continuous printing). Print up
to 2 cards at once
through parallel processing in the printer.
Do not perform the parallel processing (prints one card at a
Do not print another
card until the previous card finishes printing (normal eject).
Select the setting value.
Press the SET key, and then confirm the setting value.
Set this item according to the specification of the card printing
system.
Displays the high temperature heating cumulative time of the heat
roller at 125 deg C or higher.
Sets the error card reissue function
Sets the error card reissue function
OFF:
If an error occurs when issuing the card, discards the job.
If an error occurs when issuing the card, maintains the job.
Reissues after restoring the error state.
Select the setting value.
Press the SET key, and then confirm the setting value.
Sets the peeling operation during primary transfer
Sets the peeling operation during primary transfer.
NORMAL:
Performs the peeling operation to a position 5 mm
the peeling point of the ribbon and film.
HIGH DUTY: Performs the peeling operation to a position 15 mm
beyond the peeling
point of the ribbon and film. Use when the
tends to break easily, such as con-
tinuously issuing high density data.
Select the setting value.
Press the SET key, and then confirm the setting value.
Sets the high-quality mode for black
Sets the high-quality mode for black
OFF:
Transfers both color and black at the same speed.
ON: Reduces the transfer speed during black transfer.
Select the setting value.
Press the SET key, and then confirm the setting value.
To Next Page
Loading...
