Pop-Up
988 FTBx-88000 Series
Modify DS0/E0
RX
Apply Channel TX to RX, available for decoupled test, allows
applying the RX payload content based on the TX settings. None
will be used when TX is set to either Idle or Tone. For E0 the
timeslots 0 and 16 (PCM30 and PCM30 CRC4) are not configurable.
Timeslot 0 processes the FAS/NFAS while timeslot 16 processes the
Signaling frame.
Note: The RX timeslot selection is only configurable in a Decoupled topology
when the Apply Channel TX to RX check box is cleared. A warning is
displayed when the number of Pattern timeslot does not match between TX
and RX. This is to ensure pattern continuity between the TX and RX
interface in a MUX/DEMUX test even if used through a cross-connect device.
Pattern/None button: Select the payload content by tapping once
or several times on each timeslot until the desired content
appears: Pattern or None.
Pattern (default) uses the pattern from the received signal.
None does not use the pattern.
To Next Page
Loading...
