Setup
Power Blazer 139
Test Configurator Overview
Physical Clock Port indicates the direction, TX or RX, of the
selected clock; not displayed when Ext Clock Out is set to None.
The arrow next to the physical clock image indicates if a clock is
generated (TX, arrow pointing to the left) or received (RX, arrow
pointing to the right) at/from the physical EXT CLK port.
Physical External Reference Port indicates the port, signal, and
direction (RX) of the selected external reference signal.
Interface Block displays an overview of the interface settings and
status. Tap on the interface block to change the settings and to see
detailed status. For Dual Port topology, there is an interface block
for each port.
Protocol Block displays an overview of either the frame structure
and its parameters for Ethernet test applications or the embedded
signal for Transport test applications. This block is not present for
all tests. Tap on the protocol block to change the settings and to
see detailed status. For RFC 2544, EtherBERT, and Traffic Gen &
Mon in Dual Port topology, there is a protocol block for each port.
Test Block displays an overview of the test settings and status. Tap
on the test block to change the settings and to see detailed status.
Clock Block displays an overview of the clock settings and status.
Tap on the clock area to change the settings and to see detailed
status. For Dual Port topology, the clock block is not present but
the clock is set to Internal.
External Reference Block displays an overview of the external
reference signal settings and status. Tap on the external reference
area to change the settings and to see detailed status.
To Next Page
Loading...
