EXFO FTBx-88260 - Page 182

Setup
166 FTBx-88000 Series
Modify Structure - EtherSAM
 PHY Type allows selecting the transceiver PHY type:
For 100GE (4 Lanes): LR4/ER4 (default), SR4, CWDM4, CLR4, AOC, or
Other. The PHY type when set to any except LR4/ER4, provides access
to RS-FEC configuration (see page 305).
For 100GE (1 Lane): DR1/FR1/LR1 (default and dimmed); ensure the
other end of the circuit has the FEC enabled.
For 100GE (2 Lanes): SRBD (default and dimmed); ensure the other
end of the circuit has the FEC enabled.
For 200GE (4 Lanes): Optical (default), and AOC.
For 400GE (8 Lanes): Optical (default), AOC, and DAC.
 Connector allows the selection of the physical port (see the
Interface/Rate table above). Connectors availability depend on the
selected PHY Type; CFP8 and OSFP connectors are only available
when the PHY Type is set to Optical.
 Topology allows the selection of the network test topology:
Single Port (default) or Dual Port. Available for rates up to 10G WAN.