Test Control
768 FTBx-88000 Series
Discover Remote
Loop Up / Loop Down
Loop Up establishes the connection with the selected remote unit
and the loopback mode is set and initiated on the remote unit.
The interface IP address is used as the source address for the test
and the stream/service address has to be coupled with the
interface (refer to Couple with Interface on page 330). For Layer 4,
the UDP source port is using the one configured on the first
stream/service. For EtherSAM, since the VLAN is not coupled,
make sure to use the same VLAN configuration for the interface
and all enabled services.
Following a successful loop up, the MAC and IP addresses of the
remote unit will be used as the destination addresses for the test.
When the connection is established with the remote unit, the test
should be started locally. A message is displayed if the remote unit
cannot be reached.
Loop Down ends the connection between the local and the
remote units.
Local Module Identification
Module ID is used to easily identify this unit in case another unit is
performing a discovery scan. Up to 16 alpha-numeric characters are
allowed.
To Next Page
