CHAPTER 20
PAGE 20
PAGE DATE: 12. June 2015
MAINTENANCE MANUAL EXTRA 300LT
19 Remove tail weight.
20 Check if all switches are in Off-position and connect battery.
21 Perform operational check of electrical equipment. Shut-
off BATTERY and ALTERNATOR switches after completion.
22 Perform operational check and rigging of control system.
23 Inspect fluid filled lines for leaks.
24 Check security of main spar bolts.
25 Install wheel fairings, main fuselage cover and rear support
angle, canopy, engine cowlings, and access panels (refer to
chapter 51-00-01 and 53).
26 Check all control surfaces for freedom of movement and
security.
27 Perform a compass compensation according to „Aircraft
Inspection and Repair FAA AC 43.13“.
28 Check correct servicing of aircraft.
29 Perform an engine run up. Refer to chapter "05-20-04
Scheduled Maintenance Checks". Start the engine in
accordance with the Pilot’s Operating Handbook and
Airplane Flight Manual (POH).
30 Inspect aircraft for foreign objects.
31 Final inspection by licensed aircraft inspector.
I M P O R T A N T After first flight check fuselage interior/exterior for
fuel leaks. Check all bolts on fairings and cover sheets
for tight fit.
To Next Page
Loading...
