CHAPTER 27
PAGE 4
PAGE DATE: 7. July 2010
MAINTENANCE MANUAL EXTRA 300LT
N O T E When installing a bellcrank or control stick the spacer
sleeve inside the bearing could be displaced as shown
in Figure 2. Use a mandrel to adjust the spacer sleeve.
Figure 2 Spacer Sleeve Displaced
N O T E When installing a control surface use mandrels as
shown in the following Figure 3 to preset the control
surface. Then press out each mandrel by pushing a bolt
into the bearing.
Figure 3 Control Surface Mounting Aid
To Next Page
Loading...
