CHAPTER 73
PAGE 8
MAINTENANCE MANUAL EXTRA 300LT
PAGE DATE: 12. June 2015
7 Disconnect throttle control lever attachment by removing
cotter pin, castle nut, washers and bolt (7). Remove throttle
control lever.
Installation
Install in reverse sequence of removal observing the following
items:
1 Thread the intercom switch (5b, Figure 3) and the smoke
switch (5a) wiring through the throttle control lever (5)
before mounting the lever to the attachment bracket.
2 Tighten the throttle control lever castle nut (7) slightly.
Ensure movability of control levers (1 & 5).
To Next Page
Loading...
