CHAPTER 5
PAGE 35
PAGE DATE: 12. June 2015
MAINTENANCE MANUAL EXTRA 300LT
Tail-wheel landing gear
O 1 Inspect glass fibre spring visually for dents, cracks and
delaminations.
O 2 Inspect mounting bolts and nuts for fretting, wear, damage, stretch
and proper torque.
O 3 Check tail-wheel for general condition and function. Pay attention
to the free movement of the rudder.
O 4 Check connector springs for light precompression.
O 5 Inspect wheelfork visually for damage, dents, cracks and corrosion.
O 6 Inspect axle bolt and nut for fretting, wear, damage, and stretch.
O 7 Check rubber tire for general condition.
Engine compartment
O 1 Remove engine cowling halves.
O 2 Check firewall for dents, cracks and deformation.Visual inspection
of LJF PR 812 seals for porosity and general condition.
O 3 Inspect tubular engine mount for dents, cracks and corrosion. Check
all bolts for security and condition.
O 4 Visual inspection of rubber mounts (shock mounts) for porosity and
general condition.
O 5 Inspect flexible hoses for damage and leakage.
O 6 Check electric wiring for proper connection.
O 7 If Plane Power alternator installed: Remove alt. field brush assem-
bly and inspect brushes for excess wear. Replace brush assembly if
brushes extend less than .250” from edge of brush holder case.
O 8 Check electrical bonding braids for proper connection.
O 9 Visual inspection of inverted oil system for general condition ac-
cording to CHRISTEN 801instruction. Refer to the applicable
TEXTRON LYCOMING Operator`s or Maintenance Manual (refer
to chapter 1).
O 10 Carry out general engine check as instructed by the applicable
TEXTRON LYCOMING Operator`s or Maintance Manual (refer to
chapter 1).
O 11 Visual inspection of cowling for dents, cracks, delamination and
smoke marks.
Inspector:
Mechanic:
Inspections
Date:
Serial No.:
1000 hours
To Next Page
Loading...
