Installing the BlackDiamond 8810 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
102
6 Secure the chassis to the system rack using eight rack mounting screws. (Screws are not provided.)
Refer to Figure 52 for the screw locations
Figure 52 shows a standard rack mount. For mid-mount installation, use the same mounting locations shown in
the figure, but insert the screws through the designated slot locations of the mid-mount brackets.
Figure 52: Securing the BlackDiamond 8810 chassis to a standard rack system
7 Remove the helper bracket from the system rack after the chassis is secured. Save the bracket for
future use if you remove the chassis from the rack.
EX_172A
To Next Page
Loading...
