Extreme Networks BlackDiamond 8800 Series - Installing an Extreme Networks 700;1200 W AC PSU

Extreme Networks 700/1200 W AC PSU
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
147
You need the following tools and equipment to install or remove an Extreme Networks 700/1200 W AC
PSU:
● ESD-preventive wrist strap
● Power supply cord (110 V AC, 220 V AC, or applicable to country of use)
● Thermal protective gloves (required for removal)
Installing an Extreme Networks 700/1200 W AC PSU
CAUTION
Make sure that the Extreme Networks 700/1200 W AC PSU circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install an Extreme Networks 700/1200 W AC PSU:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle, which is located on the top-left corner of the switch front panel.
2 Verify that the Extreme Networks 700/1200 W AC PSU is right side up and the locking handle is
open (see Figure 87).
Figure 87: Extreme Networks 700/1200 W AC PSU with locking handle open
EX_015