Extreme Networks BlackDiamond 8800 Series - Initial Management Access

Installing the BlackDiamond 12802 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
120
To ground the chassis:
1 Locate the grounding point on the back of the chassis (Figure 67).
Figure 67: Back of BlackDiamond 12802 chassis
2 Strip 0.5-inch (1.2-cm) of insulation from the stranded copper wire cable.
3 Insert the stripped wire into the cable lug.
CAUTION
Be sure that no copper is visible between the lug and the cable insulation.
4 Crimp the lug onto the cable according to the manufacturer’s specifications.
5 Insert the screws through the lug and into the grounding point on the back of the chassis.
6 Connect the other end of the wire to a known reliable earth ground point at your site.
Initial Management Access
For instructions on accessing the switch for initial management setup, see Chapter 2, “Initial
Management Access.”
Fan tray
Grounding
point
PSU/fan controller
module
Power
supplies
BD_142A