Extreme Networks BlackDiamond 8800 Series - MID-Mount Rack Installation

Installing a BlackDiamond 10808 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
132
Mid-Mount Rack Installation
To install the chassis in a mid-mount position, use the optional mid-mount kit.
To mount the chassis into the rack using the mid-mount kit:
1 Locate the helper bracket.
2 Mount the helper bracket in the lowest available position in the rack using four appropriate screws
(not provided), as shown in Figure 78.
Figure 78: Helper bracket for mounting the BlackDiamond 10808 switch
3 Attach a mid-mount flange to each side of the BlackDiamond 10808 chassis using the provided
screws.
Use the appropriate flange for the left and right side, as shown in Figure 79.
EX_086A