Summit Family of Switches
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
274
Summit X450e-48p Switch Rear Panel
Figure 194 shows the rear panel of the Summit X450e-48p switch.
Figure 194: Summit X450e-48p switch rear panel
The rear panel on the Summit X450e-48p switch includes:
● Slot for a Summit option card
■ Summit XGM2-2xn option card, which allows you to add up to two 10 Gigabit XENPAK modules
OR
■ Summit XGM2-2xf option card, which allows you to add up to two 10 Gigabit XFP modules
For information regarding these compatible Summit option cards, see “Summit XGM2-2xn Option Card” on
page 297 or “Summit XGM2-2xf Option Card” on page 302.
● Management port
■ Used to connect the system into a parallel management network for administration.
OR
■ Used to connect an Ethernet cable directly from your laptop into the management port to view
and locally manage the switch configurations.
● Two LEDs for the management port, located in the bottom corners of the port.
● Two high-performance stacking ports
● Redundant power input connector for optional connection to an EPS-C chassis, which can hold up to
three EPS-600LS external power modules. The PoE capability of the Summit X450e-48p switch varies
depending on the number of external power modules in use. For complete details, see “EPS-600LS
External Power Module” on page 328. The connecting redundant power supply cable is shipped
with the EPS-C chassis.
● AC power socket
The switch automatically adjusts to the supply voltage. The power supply operates from 100 VAC to
240 VAC.
SH_033
10 Gigabit
uplink option
Management port
10 Gigabit
stacking ports
Power socket
External power
supply connection
To Next Page
Loading...
