Installing a BlackDiamond 10808 Series Module
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
179
To disconnect a cable from a 10G4Ca module:
1 Holding the cable connector with one hand, press it against the module front panel as you use the
other hand to pull back evenly on the latch (Figure 109).
Figure 109: Disconnecting a cable from a 10G4Ca port
2 Make sure the latch is pulled into the fully disengaged position.
3 Pull the cable connector straight off the port connector.
Installing a BlackDiamond 10808 Series Module
BlackDiamond 10808 series modules are hot-swappable. You can insert a BlackDiamond 10808 series
MSM or I/O module at any time, without causing disruption of network services. Complete the action
of inserting a BlackDiamond 10808 series module in a reasonable time frame. Be sure to insert the
module completely to avoid partial connection of backplane connectors.
The BlackDiamond 10808 switch comes with eight blank front panels already installed. Use a blank
front panel to fill slots not occupied by I/O modules or switch management modules. For information
about how to install a blank front panel, see “BlackDiamond Series Blank Front Panels” on page 185.
You need the following tools and equipment to install a module
● ESD-preventive wrist strap (provided)
● # 2 Phillips screwdriver
● Appropriate type of cable for the module if you are installing an I/O module
BD_158
To Next Page
Loading...
