EasyManua.ls Logo

Extreme Networks BlackDiamond 8800 Series - External Psus; Internal PSU; Summit X450 E-48 P Power Supplies

Extreme Networks BlackDiamond 8800 Series
424 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Summit X450e Series Switches
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
275
Summit X450e-48p Power Supplies
Internal PSU. The internal Summit X450e-48p PSU is capable of 370 W of PoE power: 15.4 W supplied
to each port for a 24 port configuration and 7.7 W supplied to each port for a 48 port configuration or
any combination of ports where total PoE power does not exceed 370 watts. If the total system demands
exceed this power limit, the user may specify:
Port priorities to identify which ports should be ranked higher when allocating power
Port disconnect precedence to specify the method of shutting off ports when not enough PoE power
is available
NOTE
A full discussion of these concepts may be found in the ExtremeXOS 12.0 Concepts Guide, Power over Ethernet
section.
External PSUs. The Summit X450e-48p switch may be powered by one, two, or three external power
modules through the redundant power input connector on the rear of the switch.
The EPS-C (External Power Supply Chassis) is shipped with the redundant power supply cable that
connects to the redundant input connector on the rear of the switch. The EPS-C chassis can hold from
one to three 600-Watt EPS-600LS (External Power Module) units.
The PoE capability of the Summit X450e-48p switch varies depending on the number of external power
modules in use. Table 30 summarizes the PoE power behavior for the Summit X450e-48p switch based
on the number of power supply modules in use.
For complete details, see “EPS-600LS External Power Module” on page 328.
Table 30: Number of external PSUs and corresponding PoE behavior
Internal PSU
Status
EPS-600LS (1x) EPS-600LS (2x) EPS-600LS (3x)
External PSU/Chassis
Failed/Disconnected
Internal PSU:
Power On
370 W of
redundant power
740 W of
external power only
Internal PSU disabled
740 W of
external power only
with 2:1 redundancy
Internal PSU disabled
370 W of
internal power only
Internal PSU:
Power Failure
370 W of
external power only
740 W of
external power only
740 W of
external power only
with 2:1 redundancy
No PoE power

Table of Contents

Related product manuals