Extreme Networks BlackDiamond 8800 Series - 10 G4 X I;O Module

BlackDiamond 8800 Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
58
All Gigabit Ethernet ports on this module use SPF fiber mini-GBIC connectors.
The default configuration of the G24X module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The G24X module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the G24X module, see “I/O Module LEDs” on
page 66.
10G4X I/O Module
Figure 21 shows the 10G4X I/O module.
Figure 21: 10G4X I/O module
The 10G4X I/O module has four unpopulated XENPAK-based 10 Gigabit Ethernet ports.
The default configuration of the 10G4X I/O module is as follows. All ports:
● Are added to the default VLAN as untagged.
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The 10G4X I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the 10G4X I/O module, see “I/O Module LEDs”
on page 66.
Module status LEDs 10 Gbs ports
ASP040A