Summit External Power Supplies (EPS)
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
332
Figure 234: Installing the Redundant Power Cord
Installing an EPS-600LS
To install an EPS-600LS unit into an EPS-C:
1 Slide the EPS-600LS into an empty slot in the EPS-C (see Figure 235).
Be sure that empty slots in the EPS-C chassis are always covered by a cover plate when not in use. The EPS-C is
shipped with slots 2 and 3 covered and with slot 1 open. Extreme Networks recommends that you populate slot
1 with an EPS-600LS unit first, but this is not required. You can install EPS-600LS units into any of the slots
in the EPS-C. The installation sequence does not affect the performance of the power supply units, but empty
slots must be covered at all times.
Figure 235: Installing the EPS-600LS unit in the EPS-C chassis
EPS-C_03A
Redundant Power Output
! See Manual
Connect First
! See Manual
O.T.P
DC OK
AC OK
To Next Page
Loading...
