Extreme Networks BlackDiamond 8800 Series - Summit XGM2-2 Xn Option Card

Summit XGM2-2xn Option Card
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
297
Figure 204: Installing the Summit XGM-2xn option card
5 Using the screws from the cover plate, secure the Summit XGM-2xn option card to the back panel of
the switch.
6 Refer to “Installing or Removing XENPAK Modules” on page 300 for information on installing or
replacing the XENPAK modules in the Summit XGM-2xn option card.
NOTE
If you install only one XENPAK module in the Summit XGM-2xn option card, attach the supplied cover plate over
the remaining open module slot.
Be sure that the option slot always has either an installed Summit option card or a faceplate over the opening.
An open slot could divert air from the switch and cause overheating.
Summit XGM2-2xn Option Card
The Summit XGM2-2xn option card allows you to add up to two 10-gigabit XENPAK modules to the
following switches:
● Summit X450a-24t switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450a-24tDC switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450a-24x switch, running ExtremeXOS 11.6.1 (or later)
● Summit X450a-24xDC switch, running ExtremeXOS 11.6.1 (or later)
● Summit X450a-48t switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450e-24p switch, running ExtremeXOS 11.5.0 (or later)
● Summit X450e-48p switch, running ExtremeXOS 11.6.1 (or later)
ES4K042
Summit Option
Card