Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
307
22 Summit External Power Supplies (EPS)
This chapter describes external power supplies available for use with the Summit family of switches.
● Overview on page 307
● Safety on page 308
● EPS-160 External Power Module (with EPS-T) on page 309
● EPS-LD External Power Supply Unit on page 313
● EPS-500 External Power Supply Unit on page 317
● EPS-150DC External Power Module (with EPS-T2) on page 321
● EPS-600LS External Power Module on page 328
Read the information in this chapter thoroughly before you attempt to install or remove an External Power Supply.
This manual focuses on products supported by ExtremeXOS only. The compatible switches called out in each section
in this chapter run ExtremeXOS software. For a list of compatible switches running ExtremeWare, refer to the
Consolidated “i” and “e” Hardware Installation Guide.
Overview
Summit X450 family and X250e series switches are shipped with an internal power supply, which
supplies all of the power needed for most switch operation. An optional redundant power supply can
be added to protect against a power supply failure and to provide increased support for PoE operation
on applicable switches.
Refer to Table 38 for a compatibility chart of Summit X450 family switches and external power supplies.
Table 38: Summit switch and EPS compatibility
Switch Model Compatible EPS Model Number
Summit X450 Series Switches
Summit X450-24t EPS-160 External Power Module with EPS-T EPS-160: 10907
EPS-T: 10906
Summit X450-24x EPS-160 External Power Module with EPS-T EPS-160: 10907
EPS-T: 10906
Summit X450a Series Switches
Summit X450a-24t EPS-LD External Power Supply Unit 45019
Summit X450a-24tDC EPS-150DC External Power Module with EPS-T2 EPS-150DC: 10909
EPS-T2: 10910
Summit X450a-24x EPS-LD External Power Supply Unit 45019
Summit X450a-24xDC EPS-150DC External Power Module with EPS-T2 EPS-150DC: 10909
EPS-T2: 10910
Summit X450a-48t EPS-500 External Power Supply Unit 10911
To Next Page
Loading...
