Extreme Networks BlackDiamond 8800 Series - Connecting Cable Holders

Using the Cable Holders and Cable Clips
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
203
Figure 132: BlackDiamond cable holders and clips
Connecting Cable Holders
Each cable holder holds up to 12 separate cables, with 6 on each side. Connect cable holders end to end
as needed to accommodate the number of cables you need to organize.
To connect the cable holders:
1 Hold two cable holders as shown in Figure 133.
Make sure that one locking tab at the joint is on top and the other is on the bottom.
Figure 133: Connecting cable holders
Interlocking
cable holder
and cable clips
ENIN005A
Side view
Cable
holder
Cable
clips
ENIN003