Extreme Networks BlackDiamond 8800 Series - Blackdiamond 8806;12804 AC Power Cord Retainer Channel; Pre-Installation Requirements; Installing the Blackdiamond 8806;12804 AC Power Cord Retainer Channel

BlackDiamond AC Power Cord Retaining Brackets
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
194
BlackDiamond 8806/12804 AC Power Cord Retainer
Channel
This power cord retainer is compatible with the following BlackDiamond switches:
● Extreme Networks BlackDiamond 8806 switch
● Extreme Networks BlackDiamond 12804 switch
Pre-Installation Requirements
Connect all AC power cords before you install the power cord retaining bracket.
The following tools and equipment are required before installing or removing the BlackDiamond 8806/
12804 AC power cord retainer channel bracket:
● ESD-preventive wrist strap
● #2 Phillips screwdriver
Installing the BlackDiamond 8806/12804 AC Power Cord
Retainer Channel
To install the BlackDiamond 8806/12804 AC power cord retainer channel:
1 Attach the ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle on the top-left corner of the switch front panel.
2 Starting at the left, insert the plug of each AC power cord into the power connectors on the switch,
and lift each installed power cord over the previous plug (see Figure 122).
Verify that all installed AC power cords are firmly plugged into the power connectors.
Figure 122: Installing and routing the AC power cords
EX_138
Starting at the left, insert each plug
and lift power cord over previous plug