Extreme Networks BlackDiamond 8800 Series - 10 G4 Ca I;O Module; 10 G4 Xa I;O Module

I/O Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
63
10G4Xa I/O Module
Figure 26 shows the 10G4Xa I/O module.
Figure 26: 10G4Xa I/O module
The 10G4Xa I/O module has four XFP-based 10-gigabit Ethernet ports.
The default configuration of the 10G4Xa I/O module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The 10G4Xa I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the 10G4Xa I/O module, see “I/O Module LEDs”
on page 66.
10G4Ca I/O Module
Figure 26 shows the 10G4Ca I/O module.
Figure 27: 10G4Ca I/O module
The 10G4Ca I/O module has four 10-gigabit Ethernet ports that use CX4 interface connectors.
The default configuration of the 10G4Ca I/O module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
10G4Xa10 G 4Xa
10GBASE-X XFP
41612
Module status LEDs 10 Gbs ports
BD_155
10G4Ca1 0G4C a
10GBASE-CX4
41613
Module status LEDs 10 Gbs ports
BD_156