Extreme Networks BlackDiamond 8800 Series - Connecting a Stacking Cable to a Stacking Port

Building a SummitStack Configuration
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
283
Figure 197: SummitStack cable connections using four Summit switches
Connecting a Stacking Cable to a Stacking Port
To connect a Summit stacking cable:
1 Align the cable connector with the stacking port connector on the back of the first switch
(Figure 198).
2 Firmly press the cable connector into place on the mating stacking port connector.
3 Align and tighten the retaining screws on the cable connector.
Repeat steps 1 through 3 to connect the cable to the second switch.
Table 34: Recommended stacking port connections (4-switch stack)
Slot
Number
Connect Stack Port 1 on
this switch to . . .
Connect Stack Port 2 on
this switch to . . .
1 Slot 4 Port 2 Slot 2 Port 1
2 Slot 1 Port 2 Slot 3 Port 1
3 Slot 2 Port 2 Slot 4 Port 1
4 Slot 3 Port 2 Slot 1 Port 1
BD_164A