Extreme Networks BlackDiamond 8800 Series - Summit XGM-2 Xn Option Card; Mixing ZR Xenpaks with Other Types

Summit XGM-2xn Option Card
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
295
Summit XGM-2xn Option Card
The Summit XGM-2xn option card allows you to add up to two 10-gigabit XENPAK modules to the
following switches:
● Summit X450-24x switch, running ExtremeXOS 11.2.0 (or later)
● Summit X450-24t switch, running ExtremeXOS 11.2.0 (or later)
The Summit XGM-2xn option card is compatible with the following 10-gigabit XENPAK modules:
● SR XENPAK module, operating in the 850 nm range
● LR XENPAK module, operating in the 1310 nm range
● ER XENPAK module, operating in the 1550 nm range
● ZR XENPAK module, operating in the 1550 nm range
● LX-4 XENPAK module, operating in the 1269-1355 nm range
NOTE
For more information about these XENPAK modules, refer to “XENPAK Interfaces” on page 354.
NOTE
Standards-based CX-4 XENPAKs are also recognized by ExtremeXOS; contact your CX-4 module vendor to obtain
these.
Mixing ZR XENPAKs with Other Types
Table 37 lists the supported combinations of XENPAK types using ZR XENPAKs in a Summit X450
series switch. You can either install one ZR XENPAK and leave one slot empty or install one ZR
XENPAK and one SR XENPAK; the Summit X450 series switch does not support any other XENPAK
combinations when a ZR XENPAK module is installed. You must put the specified modules in the
specified slots, as shown in Table 37, for the switch to discover the ZR XENPAK correctly.
.
Table 37: Summit X450 ZR XENPAK combinations
Left Slot Right Slot
ZR XENPAK Empty
ZR XENPAK SR XENPAK