Summit External Power Supplies (EPS)
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
322
Pre-Installation Requirements
You need the following tools and equipment to rack mount the EPS-T2:
● # 1 Phillips screwdriver
● Rack mount kit
Rack Mounting the EPS-T2
Do not use the rack mount brackets to suspend the EPS-T2 from under a table top or desk, or to attach the EPS-T2
to a wall.
To rack mount the EPS-T2:
1 Place the EPS-T2 upright on a hard flat surface, with the front facing you.
2 Remove the mounting bracket kit (including screws) from the packaging.
3 Locate a mounting bracket over the mounting holes on one side of the unit.
4 Insert the screws and fully tighten with a screwdriver, as shown in Figure 227.
Figure 227: Fitting the mounting bracket
5 Repeat steps 3 and 4 for the other side of the EPS-T2.
6 Slide the EPS-T2 into a 19-inch rack and secure it using appropriate rack-mount screws.
Installing an EPS-150DC
Install the EPS-T2 before you begin installing the EPS-150DC.
Always be sure that the DC circuit is de-energized before connecting or disconnecting the DC wiring harness at the
DC power socket on the rear of the EPS-150DC unit, and before connecting or disconnecting the redundant power
cord between the switch and the EPS-150DC unit.
To Next Page
Loading...
