Extreme Networks BlackDiamond 8800 Series - Installing an Extreme Networks 600;900 W AC PSU

Extreme Networks Power Supply Units for BlackDiamond Switches
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
154
Installing an Extreme Networks 600/900 W AC PSU
CAUTION
Make sure that the Extreme Networks 600/900 W AC PSU circuit is not overloaded. Use proper over-current
protection, such as a circuit-breaker, to prevent over-current conditions.
To install an Extreme Networks 600/900 W AC PSU:
1 Attach an ESD-preventive wrist strap to your wrist and connect the metal end to the ground
receptacle, which is located on the top-left corner of the switch front panel.
2 Verify that the Extreme Networks 600/900 W AC PSU is right side up and the locking handle is
open (see Figure 90).
Figure 90: Extreme Networks 600/900 W AC PSU with locking handle open
3 Carefully slide the Extreme Networks 600/900 W AC PSU all the way into the power supply bay
(see Figure 91).
CAUTION
Do not slam the Extreme Networks 600/900 W AC PSU into the system switch backplane. Use the locking handle to
secure the Extreme Networks 600/900 W AC PSU into the system switch.
Figure 91: Inserting a 600/900 W AC PSU into the power supply bay
EX_015
EX 174