Extreme Networks BlackDiamond 8800 Series - Lr Xenpak

XENPAK Interfaces
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
355
Table 65 lists specifications for the SR XENPAK module
.
NOTE
The launch power (measured using the average power method used by power meters) is measured at the factory. The
average launch power minimum value is provided as a reference, not a pass/fail criterion.
LR XENPAK
The LR XENPAK supports single-mode fiber (SMF) and has SC connectors.
The LR XENPAK requires the software versions listed in Table 66.
Table 65: SR XENPAK module specifications
Parameter Minimum Maximum
Average launch power -7.3 dBm –1.3 dBm
Channel insertion loss:
62.5 μm (160/200 MHz*km)
62.5 μm (200 MHz*km)
50 μm (400 MHz*km)
50 μm (500 MHz*km)
50 μm (2000 MHz*km)
1.6 dB
1.6 dB
1.7 dB
1.8 dB
2.6 dB
Wavelength range 840 nm 860 nm
Operating distance range
(depends on type and modal bandwidth)
62.5 μm MMF (160 MHz*km)
62.5 μm MMF (200 MHz*km)
50 μm MMF (400 MHz*km)
50 μm MMF (500 MHz*km)
50 μm MMF (2000 MHz*km)
26 m
33 m
66 m
82 m
300 m
Maximum receiver sensitivity in OMA -11.1 dBm
Table 66: LR XENPAK software requirements
Switch Model Required Software
BlackDiamond Switches
BlackDiamond 10808 ExtremeXOS 11.1.1 or later
BlackDiamond 8800 series ExtremeXOS 11.1.1 or later
BlackDiamond 12804 ExtremeXOS 11.4 or later
BlackDiamond 12802 ExtremeXOS 12.0 or later
Summit Switches
Summit X450 series ExtremeXOS 11.2.0 or later
Summit X450a series ExtremeXOS 11.2.0 or later
Summit X450e series ExtremeXOS 11.2.0 or later