Extreme Networks BlackDiamond 8800 Series - G48 Xa I;O Module

BlackDiamond 8800 Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
62
The default configuration of the G48Ta I/O module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
● Operate in autonegotiation mode
The G48Ta I/O module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the G48Ta I/O module, see “I/O Module LEDs”
on page 66.
G48Xa I/O Module
Figure 25 shows the G48Xa I/O module.
Figure 25: G48Xa I/O module
The G48Xa I/O module has 48 1000BASE-X ports (SPF fiber mini-GBIC connectors).
The default configuration of the G48Xa module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
The G48Xa module has the following LEDs:
● Module status
● Module diagnostics
● Port status
For information about the LEDs and their activity on the G48Xa module, see “I/O Module LEDs” on
page 66.
Module status LEDs
ASP049A
1000BASE-X
ports