Extreme Networks BlackDiamond 8800 Series - 10 G6 X Leds; XENPAK Ports

About the BlackDiamond 10808 I/O Modules
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
87
If you have one MSM installed, all ports on the 10G6X module are switched through that MSM. If you
have two MSMs installed, the top three ports on the 10G6X module are switched through the MSM in
slot A, and the bottom three ports are switched through the MSM in slot B during normal operation.
The default configuration of the 10G6X module is as follows. All ports:
● Are added to the default VLAN as untagged
● Inherit the properties of the default VLAN (for example, protocol type and VLANid)
XENPAK Ports
The 10G6X module supports any of the following XENPAKs:
● SR XENPAK
● LR XENPAK
● ER XENPAK
● ZR XENPAK
● LX4 XENPAK
● LW XENPAK
● CX4 XENPAKs are also supported with Extreme Networks devices; contact your vendor to obtain these.
NOTE
For more information about the supported XENPAK types and specifications, see “XENPAK Interfaces” on page 354.
10G6X LEDs
The 10G6X module has the following LEDs:
● Module status
● Port status
For information about the LEDs and their activity on the 10G6X module, see “I/O Module LEDs” on
page 91.