Installing the BlackDiamond 8806 and BlackDiamond 12804 Chassis
Extreme Networks Consolidated ExtremeXOS Hardware Installation Guide
106
Unpacking the BlackDiamond 8806/12804 Chassis
Do not remove the nylon straps until you are ready to open the chassis package.
To unpack the BlackDiamond 8806/12804 chassis:
1 Remove the nylon straps from around the shipping carton.
2 Open the top flaps and remove the accessories and documentation pack from the shipping carton
(see Figure 54). Lift out the packing foam.
Figure 54: Removing accessories from the BlackDiamond 8806/12804 chassis shipping carton
3 Release the clip locks (see Figure 55).
a Place your thumb and index finger inside the clip lock touching the prongs.
b Squeeze the prongs inward, applying equal pressure on each side.
c Pull the prongs outward until the clip lock is released from the carton.
Repeat steps 2a through 2c to release each of the remaining clip locks.
EX_110
Power cord retaining bracket
BlackDiamond documentation pack
with ESD-preventive wrist strap
19-inch helper bracket
To Next Page
Loading...
